Cable gear FA

for Vespa all models
with PTFE-sleeve and barrel nipple
grey
l (cable)=2000mm

1,6mm/5,5 mm
steel, zinc plated
l (sleeve)=1650mm

Grade B – decent repair
This product fits on almost all products Product description
Cables are among the most important spare parts. You should carry a spare set on your scooter and you should also keep a spare set in your garage at home. Snapped cables are an annoyance on every excursion. Cables which are hard to pull take their toll on the nerves and tendons. Frayed cables have to be replaced. For this reason, whether it is a restoration or annual service, replacing the cables on a regular basis is recommended. We only stock high quality cables which we fit to our own scooters. They are available as individual cables, cables with sleeve and optionally also with PTFE sleeve. They differ in terms of their length and diameter and the appearance and colour of the sleeve. Certain throttle, choke and brake cables differ depending on the specific model. Cables with PTFE sleeves are perfect for tight installation radii and are very easy to operate. The interior section of the sleeve has a special lining which has a clearly superior effect on the running and the lifespan of the cable. These cables do not require lubricating either.
Order screw nipple and new adjusting screws at the same time! Everything apart from PTFE has to be lubricated with oil or grease! Gear cable:With barrel nipple: For attachment to the switch tube, screw nipple PART No 94220000 is required for the rear end. With eyelet: The cable is attached to the handle bars with bolt PART No 17713300 and retaining ring PART No 59550000/59650000. At the lower end, screw nipple PART No 94220000 is used.